This year, we constructed two models to simulate the bacteria quorum sensing process and Kill Switch. For the quorum-sensing model, we used the Gillespie algorithm in random simulation to simulate the physiological processes at macro and micro levels. Specifically, we described Acyl-homoserine lactone's concentration accurately by monitoring both production and diffusion, which is first-of-its-kind to reveal details of the process, and developed originally by us. We further improved the model from 19Fudan team to better model the quorum sensing process for various bacteria growing stages. For the stage change caused by the anti-microbial peptide (mcbA), we provided explanations to its observed dynamic stability. For the Kill Switch model, based on the experimental data from 19BNU team, we improved the logistic equation, adjusted the promoter properties according to more suitable literature references, and made sensitivity analysis – and we obtain better and more insightful results.

In the first model, we describe the quorum sensing process in three parts. In Model 1.1, we discuss the change of AHL concentration in a single cell. AHL is produced in bacteria and transported to the surrounding environment through free diffusion. Since the number of molecules in a single section is small and random, we adopted Gillespie algorithm to simulate the trend of molecule numbers under the random process. In model 1.2, we followed the discussion in 1.1. To know when the quorum sensing switch is turned on, it is necessary to know polymer concentration formed by AHL and LuxR when AHL concentration is high enough. Our results demonstrate that polymer concentration remains dynamically stable even in a single cell, which guarantees our system's stable operation. In Model 1.3, we discuss the role of antimicrobial peptide circuits. Since the loop will open when the concentration of AHL increases and will close when the concentration is low enough, it forms a dynamic equilibrium. We use a phase diagram to describe this steady state.

In this model, we simulate changes in the number of AHL in a cell. As mentioned above, AHL is generated inside the cell and transported out by free diffusion. In the initial stage, for AHL's concentration outside the bacteria is approximately 0, free diffusion is basically not inhibited and only related to AHL's concentration inside the cell. We believe that the main physiological processes about AHL are as follows:

Firstly,the expression of LuxI and LuxR:

Then,the degradation of LuxI and LuxR:

The production of AHL and its diffusion outside the cell:

Lastly,the combination and dissociationof AHL and LuxR:

In this matrix, each row is one substance, and each column is one reaction. The reactants per molecule are represented by -1, and the products per molecule are represented by 1. Set the order of the reactants to LuxI, LuxR AHLprecursor, AHL, RA, reaction sequence in the order listed above, then the matrix should be:

After each reaction, the number of molecules changes by the number of a column. What column is that? The probability is proportional to the rate of reaction. So let's figure out the rates of all the reactions.

So the probability is as follows:

According to probability theory, the time interval between each reaction follows the exponential distribution, and the parameter is the sum rate.

The current molecule number will change after each reaction, so that this algorithm can be repeated.In this certain progress,we can see that AHL molecule number is changed as follows:(We provide 2 results to gain better understanding.)

In the previous model, we have discussed the rapid emergence and spread of AHL during breeding. When the concentration of AHL is high enough, the net diffusion rate can be almost zero. At this point, the intracellular reaction occurs that is identical to model 1.1 except for diffusion. Therefore, we used the same simulation method and considered the situation before the secretion of antimicrobial peptides. We obtain the changes of RA in a cell number. Since the process is still random, we provide the results of two simulations.

As the quorum sensing switch is turned on, the antimicrobial peptides begin to kill engineering bacteria, and the number of engineering bacteria decreases. Subsequently, the concentration of AHL decreases, resulting in a decrease in RA concentration and a partial shutdown of the quorum sensing switch. Our system ensures that engineering bacteria are neither too many to affect the gut environment nor too few to function properly. We will describe this process in terms of differential equations and explain it in terms of phase diagrams.

For AHL, the increase in the number of engineered bacteria will slow down the net degradation rate of AHL, which can be described as follows:

As for engineering bacteria, there is a net growth under no other conditions. However, the increase in AHL concentration will eventually lead to a rise in antimicrobial peptides. Furthermore, antimicrobial peptides will increase the survival pressure of engineering bacteria. So we can describe the process as follows:

We set k_A-Nto 1, and obtain the following two results.The first is a phase diagram and the second is a concentration-time diagram.

In the modeling of kill Switch, we adopted the following ideas: First, we cooperated with the 19BNU team and adopted the data they tested. We found that without kill-switch, the colony number curve was similar to the logistic equation. Through data fitting, we obtained the parameters of the logistic equation. When kill-switch exists, in vitro, the toxin will increase the competitive pressure, causing parameters' change. Due to the improvement of a more efficient promoter, the competitive pressure caused by toxin can further increase when our design is adopted, and we performed sensitivity analysis here. Due to the abnormal part of the experimental data, we also selected the experimental data by referring to the literature and will explain the reasons for these anomalies.

Let's discuss logistic equation first.In this equation,the population change is caused by two factors: reproduction and competition. The reproductive rate (r) is proportional to the number of bacteria，and the competition rate (K) is proportional to the number of bacteria in the quadratic term.The equation and its solution are as follows.

Now let's consider the case when kill-switch is turned on.Competitive pressure sharply increases,casing a change in the equation above, in which α indicates additional pressure.

Furthermore, with an improvement in promoter ,the toxin-antitoxin system express better in our design.Consider the expression partition k_new and k_old.The equation of our system will be:

We visualize it here.

However, for the Chinese population, the bottlenecks are as follows:

1. 注意这里列表的写法 页面字会变深 突出内容 ol是编数字的 nts
2. calcium-supplementing pills daste
3. The body's absorptioes as calcium intake increases
4. Vegetables conta列表的写法 页面字会变深 突出内容 ol是编数字的 ul是没有标数字的列表

However, the currently popular calcium supplement method on the market is either to adjust diet or to consume a lot of calcium supplementing pills. For the elderly, they suffer from poor memory or neglect the importance of calcium pills, often forgetting to consume the supplement; for children, they often refuse to take calcium pills or to maintain some diet high in calcium, thus requiring the "liquid calcium" method to ensure sufficient calcium intake. Ho可以 继续大段内容

章节内容的分段就用p开p关

章节内容的分段就用p开p关

章节内容的分段就用p开p关 EXAM 外部链接 href尽量使用https

• 注意这里列表的写法 页面字会变深 突出内容 ul是没有标数字的列表 nts
• calcium-supple menting pills don’t haat taste
• Vegetables conta列表的写法 页面字会变深 突出内容 ol是编数字的 ul是没有标数字的列表

章节内容的分段就用p开p关

引入文字 ion.

Firstly, the product is designed for oral use and our target user is the elderly. 英文分项不需要ol或ul

1. The produc
2. The short pep
3. The expression level of short peptides has a threshold, preventing any excessive calcium absorption that might lead to hypercalcemia 注意句子超长后的回折
4. There is a kill swit.

Based on relevant research, the product is exp 章节内分段 ina. tien China has an estimated 70 million osteoporosis patien China has an estimated 70 million osteoporosis patienChina has an estimated 70 million oste oporosis patienChina has an estimated 70 million osteoporosis pat

Compared w 章节内分段 ique advantages tien China has an estimated 70 million osteoporosis patien China has an estimated 70 million osteoporosis patienChina has an estimated 70 million oste oporosis patienChina has an estimated 70 million osteoporosis pat tien China has an estimated 70 million osteoporosis patien China has an estimated 70 million osteoporosis patienChina has an estimated 70 million oste oporosis patienChina has an estimated 70 million osteoporosis pat tien China has an estimated 70 million osteoporosis patien China has an estimated 70 million osteoporosis patienChina has an estimated 70 million oste oporosis patienChina has an estimated 70 million osteoporosis pat.

Calciu 章节内分段 fety. tien China has an estimated 70 million osteoporosis patien China has an estimated 70 million osteoporosis patienChina has an estimated 70 million oste oporosis patienChina has an estima ted 70 million osteoporosis pat tien China has an estimated 70 million osteoporosis patien China has an estimated 70 million osteoporosis patienChina has an estimated 70 million oste oporosis patienChina has an estimated 70 mill ion osteoporosis pattien China has an estimated 70 million osteoporosis patien China has an estimated 70 million osteoporosis patienChina has an estimated 70 million oste oporosis patienChina has an estimated 70 million osteoporosis pat

From the us 章节内分段 etition.

每页结束需要小结，可以 ul ol 列表highlight，可以是每页第一段的另一种写法fety. tien China has an estimated 70 million osteoporosis patien China has an estimated 70 million osteoporosis patienChina has an estimated 70 million oste oporosis patienChina has an estima ted 70 million osteoporosis pat tien China has an estimated 70 million osteoporosis patien China has an estimated 70 million osteoporosis patienChina has an estimated 70 million oste oporosis patienChina has an estimated 70 mi 每页结束需要小结，可以 ul ol 列表highlight，可以是每页第一段的另一种写法